Ok, I understand the finish may be harmed. What do you do to minimize the wear and tear on the gun then?

We spend a lot of time in preparation to ensure that our molds and custom build setups will minimally grab and rub against the firearm, while at the same time ensuring for a proper fit that doesn't rattle or shake while the weapon is holstered. 

The amount of retention we aim to achieve is a proper amount of grab where a direct jolt or force won't move the weapon, while at the same time a quick smooth draw will bring the weapon out.

Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request


Powered by Zendesk